We need to observe whether the filling machine is dripping. If there is dripping, check whether the filling nozzle is broken or whether the valve is damaged, and replace it in time. Adjust the opening of the filling ball valve according to the specifications of the can filling machine. Large filling specifications need to open the valve large, small filling specifications need to open the valve small, and the valve for materials that are prone to air bubbles need to be opened small to prevent air bubbles from filling the tank. For non-foaming materials, the valve can be opened appropriately, which can improve the filling efficiency. The material in the filling tank should be sufficient. At the same time, it should be noted that if there is no bottle or the bottle is not enough to not fill, the required materials must be prepared before filling. Operators must pay attention to safety when operating the filling machine and never reach out to the filling machine operating area.
The small details we need to pay attention to after using the filling machine:
After the filling machine is used, it needs to be cleaned in time until all the materials inside the filling machine are cleaned. Check the operation of the machinery and equipment, and finally turn off the power. Clean the environment where the filling machine is located.
Pay attention to these small problems during the use of the filling machine, which not only allows us to improve the efficiency of the filling machine, but also helps us to extend the service life of the filling machine.